-
For threading manually or automatically in series on the same point.
-
Steel table T-slot at 90 degrees.
-
It enables programming and execution ( manual or automatic ) of the thread depth to one measure.
-
GAMOR HYDRAULIC TAPPING MACHINE M2-M30 Sistema métrico: M3-M60 KG/MM²: 120 BRINELL: 352 ROCKWELL HRC: 37 METRIC: M2-M30 INCHES: BSW 3/32 - 1" 1/8 BSP 1/16 - 1" 1/8 CAPACITY: M2-M30 R.P.M.: 22 a 630 MAXIMUM PRESSURE: 140 Kg /cm² MOTOR 3 PS / 2.2KW VOLTAGE 400V-III-50HZ SPEED CONTROL: ELECTRONIC SLIDING BARS LENGTH: 750 mm TABLE WORKAREA: TOTAL QUICK CHANGE CHUCK: Nº 2 31mm OIL TANK: 50 LITROS WEIGHT: 450 KgMT-M30 (M2-M30)
-
The video shows the model MTC-M45, this model MT-M45 is the same, but without the rail to lower the tapping head. -
Cooling System
-
For threading manually or automatically in series on the same point.
-
Kingpin of rapid change, with or without clutch, for placement of males, countersinks, dies, etc ...
-
TAP ADAPTERS / TAP HOLDERS
-
DIGITAL DEPTH PROGRAMMER
-
Work table with slots, lanyards and chip catcher.
-
Magnetic Base for models GN20 and GN24.
-
Magnetic Base for models GN08, GN12 and GN16.
